IP Configuration Command Set
Configuring Dynamic Host Configuration Protocol (DHCP)
12-120 Matrix DFE-Platinum and Diamond Series Configuration Guide
12.2.9.5 ip dhcp ping timeout
Use this command to specify the amount of time the DHCP server will wait for a ping reply from
an IP address before timing out.
ip dhcp ping timeout milliseconds
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command resets the ping timeout to the default value of 500:
no ip dhcp ping timeout
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router1(config)#
Command Defaults
None.
Example
This example shows how to set the DHCP ping timeout to 900 milliseconds:
number Specifies the ping timeout in milliseconds. Valid values are
100 to 10000.
Matrix>Router1(config)#ip dhcp ping timeout 900
To Next Page
Loading...
