Port Configuration Command Set
Reviewing Port Status
4-24 Matrix DFE-Platinum and Diamond Series Configuration Guide
4.3.2 Reviewing Port Status
Purpose
To display operating status, duplex mode, speed, port type, and statistical information about traffic
received and transmitted through one or all switch ports on the device.
Commands
The commands used to review port status are listed below and described in the associated sections
as shown.
• show port (Section 4.3.2.1)
• show port status (Section 4.3.2.2)
• show port counters (Section 4.3.2.3)
• show port operstatuscause (Section 4.3.2.4)
• clear port operstatuscause (Section 4.3.2.5)
To Next Page
Loading...
Need help?
General