Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
Matrix DFE-Platinum and Diamond Series Configuration Guide 3-47
3.2.4.14 set lldp port trap
Use this command to enable or disable sending LLDP notifications (traps) when a remote system
change is detected.
set lldp port trap {enable | disable} port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example enables transmitting LLDP traps on ports ge.1.1 through ge.1.6.
enable Enable transmitting LLDP traps on the specified ports.
disable Disable transmitting LLDP traps on the specified ports.
port-string Specifies the port or range of ports to be affected.
Matrix(rw)->set lldp port trap enable ge.1.1-6
To Next Page
Loading...
Need help?
General