Logging And Network Management Command Set
Configuring NetFlow
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-161
11.2.8.6 set netflow export-interval
Use this command to configure the NetFlow export interval.
set netflow export-interval interval
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write
Usage
Each DFE blade in the Matrix system will transmit a NetFlow packet when:
• It has accumulated the maximum number of NetFlow records per packet,
which is 30, or
• It has accumulated fewer than 30 NetFlow records and the active flow timer
has expired, or
• The flow expires (ages out or is invalidated).
Example
This example shows how to set the NetFlow export interval to 10 minutes
:
interval Set the active flow timer value, between 1 to 60 minutes.
The default value is 30 minutes.
Matrix(rw)->set netflow export-interval 10
To Next Page
Loading...
