Enterasys Matrix 2G4072-52 - Set Vlan

VLAN Configuration Command Set
Creating and Naming Static VLANs
Matrix DFE-Platinum and Diamond Series Configuration Guide 7-7
7.3.2.1 set vlan
Use this command to create a new static IEEE 802.1Q VLAN, or to enable or disable an existing
VLAN. Once a VLAN is created, you can assign it a name using the set vlan name command
described in Section 7.3.2.2.
set vlan {create | enable | disable} vlan-list
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to create VLAN 3:
This example shows how to disable VLAN 3:
NOTES: Each VLAN ID must be unique. If a duplicate VLAN ID is entered, the device
assumes that the Administrator intends to modify the existing VLAN.
Enter the VLAN ID using a unique number between 2 and 4094. The VLAN IDs of 0, 1,
and 4094 and higher may not be used for user-defined VLANs.
create | enable |
disable
Creates, enables or disables VLAN(s).
vlan-list Specifies one or more VLAN IDs to be created, enabled or
disabled.
Matrix(rw)->set vlan create 3
Matrix(rw)->set vlan disable 3