Routing Protocol Configuration Command Set
Configuring OSPF
Matrix DFE-Platinum and Diamond Series Configuration Guide 13-31
13.2.3 Configuring OSPF
Purpose
To enable and configure the Open Shortest Path First (OSPF) routing protocol.
OSPF Configuration Task List and Commands
Table 13-2 lists the tasks and commands associated with OSPF configuration. Commands are
described in the associated section as shown.
.
* Advanced License Required *
OSPF is an advanced routing feature that must be enabled with a license key. If you have
purchased an advanced license key, and have enabled routing on the device, you must activate
your license as described back in Section 2.2.4 in order to enable the OSPF command set. If you
wish to purchase an advanced routing license, contact Enterasys Networks Sales.
NOTE: Activating your advanced routing license, and enabling OSPF with the router
ospf and network commands are required if you want to run OSPF on the device. All
other tasks are optional.
Table 13-2 OSPF Configuration Task List and Commands
To do this... Use these commands...
If necessary, activate your advanced
routing license.
set license (Section 2.2.4.1)
Enable OSPF configuration mode,
associate a network and assign a router
ID.
router ospf (Section 13.2.3.1)
network (Section 13.2.3.2)
router id (Section 13.2.3.3)
Configure OSPF Interface Parameters.
• Set the cost of sending a packet on
an OSPF interface.
ip ospf cost (Section 13.2.3.4)
To Next Page
Loading...
Need help?
General