Enterasys Matrix 2G4072-52 - Show Router Telnet

General Configuration Command Set
Starting and Configuring Telnet
2-126 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.8.4 show router telnet
Use this command to display the state of Telnet service to the router.
show router telnet
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the state of Telnet service to the router:
Matrix(rw)->show router telnet
Telnet to Router IP is enabled