Enterasys Matrix 2G4072-52 - Set Ip Address

General Configuration Command Set
Setting Basic Device Properties
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-45
2.2.3.2 set ip address
Use this command to set the system IP address, subnet mask and default gateway.
set ip address ip-address [mask ip-mask] [gateway ip-gateway]
Syntax Description
Command Defaults
If not specified, ip-mask will be set to the natural mask of the ip-address and
ip-gateway will be set to the ip-address.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the system IP address to
10.1.10.1 with a mask of 255.255.128.0
and a default gateway of 10.1.0.1:
ip-address Sets the IP address for the system.
mask ip-mask (Optional) Sets the system’s subnet mask.
gateway ip-gateway (Optional) Sets the system’s default gateway (next-hop
device).
Matrix(rw)->set ip address 10.1.10.1 mask 255.255.128.0 gateway 10.1.10.1