Enterasys Matrix 2G4072-52 - Set Cos Reference Txq

Policy Classification Configuration Command Set
Configuring Policy Class of Service (CoS)
Matrix DFE-Platinum and Diamond Series Configuration Guide 8-85
8.3.3.18 set cos reference txq
Use this command to set a Class of Service inbound rate limiting reference configuration.
set cos reference txq group-type-index reference queue number
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to configure inbound rate limiting reference entry 0 for port group 0.1
referencing resources defined by TXQ resource entry 0:
group-type-index Specifies a transmit queue port group/type index for this
entry. Valid entries are in the form of group.type. Group
can be 0-7, with 0 designating the default group, and 1-7
reserved for user-defined groups. Default port type values
cannot be changed, and are 0 for the Matrix
DFE-Platinum 7G4270-12 module, and 1 for all other
modules.
reference Specifies a reference number to be associated with this
entry.
queue number Specifies a transmit queue resource ID to bind to this
entry.
Matrix(rw)->set cos reference irl 0.1 0 queue 0