Configuring LACP
Configuring Link Aggregation
Matrix DFE-Platinum and Diamond Series Configuration Guide 4-109
4.5.4.8 clear lacp static
Use this command to remove specific ports from a Link Aggregation Group.
clear lacp static lagportstring port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to remove Fast Ethernet port 6 in module 1 from the LAG of aggregator
port 48:
lagportstring Specifies the LAG aggregator port from which ports will
be removed.
port-string Specifies the port(s) to remove from the LAG. For a
detailed description of possible port-string values, refer
to Section 4.1.1.
Matrix(rw)->clear lacp static lag.0.48 fe.1.6
To Next Page
Loading...
