Logging And Network Management Command Set
Configuring Simple Network Time Protocol (SNTP)
11-134 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.6.12 set sntp poll-timeout
Use this command to set the poll timeout (in seconds) for a response to a unicast SNTP request.
set sntp poll-timeout timeout
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the SNTP poll timeout to 10 seconds
:
timeout Specifies the poll timeout in seconds. Valid values are 1 to
30.
Matrix(rw)->set sntp poll-timeout 10
To Next Page
Loading...
