Port Configuration Command Set
Setting Speed and Duplex Mode
Matrix DFE-Platinum and Diamond Series Configuration Guide 4-45
4.3.4.3 show port duplex
Use this command to display the default duplex setting (half or full) for one or more ports.
show port duplex [port-string]
Syntax Description
Command Defaults
If port-string is not specified, default duplex settings for all ports will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the default duplex setting for 1-Gigabit Ethernet port 14 in
module 3:
port-string (Optional) Displays default duplex setting(s) for
specific port(s). For a detailed description of possible
port-string values, refer to Section 4.1.1.
Matrix(rw)->show port duplex ge.3.14
default duplex mode is full on port ge.3.14.
To Next Page
Loading...
Need help?
General