Discovery Protocols Command Set
Cisco Discovery Protocol
Matrix DFE-Platinum and Diamond Series Configuration Guide 3-19
3.2.3.5 set ciscodp holdtime
Use this command to set the time to live (TTL) for Cisco Discovery Protocol PDUs. This is the
amount of time (in seconds) neighboring devices will hold PDU transmissions from the sending
device.
set ciscodp holdtime time
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the Cisco Discovery Protocol hold time to 180 seconds:
time Specifies the time to live for CiscoDP PDUs. Valid values
are 10 - 255.
Matrix>set ciscodp holdtime 180
To Next Page
Loading...
