Routing Protocol Configuration Command Set
Configuring OSPF
13-74 Matrix DFE-Platinum and Diamond Series Configuration Guide
13.2.3.30 debug ip ospf
Use this command to enable OSPF protocol debugging output.
debug ip ospf {subsystem}
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command disables OSPF protocol debugging output.
no debug ip ospf {subsystem}
Command Type
Router command.
Command Mode
Privileged EXEC: Matrix>Router1#
Command Defaults
None.
Example
This example shows how to enable OSPF protocol debugging output to display information about
Link State Advertisement generation:
subsystem Specifies the OSPF subsystem for which protocol
debugging will be enabled. Valid entries and their
associated outputs are:
• adj - OSPF adjacency events
• flood - OSPF flooding
• lsa-generation - OSPF Link State Advertisement
generation
• packet - OSPF packets
• retransmission - OSPF retransmission events
Matrix>Router1#debug ip ospf lsa-generation
To Next Page
Loading...
