SNMP Configuration Command Set
Reviewing SNMP Statistics
5-6 Matrix DFE-Platinum and Diamond Series Configuration Guide
5.3.1.1 show snmp engineid
Use this command to display the SNMP local engine ID. This is the SNMP v3 engine’s
administratively unique identifier.
show snmp engineid
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display SNMP engine properties:
Table 5-2 shows a detailed explanation of the command output.
Matrix(rw)->show snmp engineid
EngineId: 80:00:15:f8:03:00:e0:63:9d:b5:87
Engine Boots = 12
Engine Time = 162181
Max Msg Size = 2048
Table 5-2 show snmp engineid Output Details
Output What It Displays...
EngineId String identifying the SNMP agent on the device.
Engine Boots Number of times the SNMP engine has been
started or reinitialized.
Engine Time Time in seconds since last reboot.
Max Msg Size Maximum accepted length, in bytes, of SNMP
frame.
To Next Page
Loading...
Need help?
General