Configuring LACP
Configuring Link Aggregation
Matrix DFE-Platinum and Diamond Series Configuration Guide 4-99
4.5.4 Configuring Link Aggregation
Purpose
To disable and re-enable the Link Aggregation Control Protocol (LACP), to display and configure
LACP settings for one or more aggregator ports, and to display and configure the LACP settings for
underlying physical ports that are potential members of a link aggregation.
Commands
The commands used to review and configure LACP are listed below and described in the associated
section as shown.
• show lacp (Section 4.5.4.1)
• set lacp (Section 4.5.4.2)
• clear lacp state (Section 4.5.4.3)
• set lacp asyspri (Section 4.5.4.4)
• set lacp aadminkey (Section 4.5.4.5)
• clear lacp (Section 4.5.4.6)
• set lacp static (Section 4.5.4.7)
• clear lacp static (Section 4.5.4.8)
• show lacp singleportlag (Section 4.5.4.9)
• set singleportlag (Section 4.5.4.10)
• clear singleportlag (Section 4.5.4.11)
• show port lacp (Section 4.5.4.12)
• set port lacp (Section 4.5.4.13)
• clear port lacp (Section 4.5.4.14)
• show lacp flowRegeneration (Section 4.5.4.15)
• set lacp flowRegeneration (Section 4.5.4.16)
• clear lacp flowRegeneration (Section 4.5.4.17)
• show lacp outportAlgorithm (Section 4.5.4.18)
• set lacp outportAlgorithm (Section 4.5.4.19)
• clear lacp outportAlgorithm (Section 4.5.4.20)
To Next Page
Loading...
Need help?
General