Enterasys Matrix 2G4072-52 - Clear Snmp Targetaddr

SNMP Configuration Command Set
Configuring SNMP Target Addresses
Matrix DFE-Platinum and Diamond Series Configuration Guide 5-51
5.3.6.3 clear snmp targetaddr
Use this command to delete an SNMP target address entry.
clear snmp targetaddr targetAddr
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to clear SNMP target address entry “tr”:
targetAddr Specifies the target address entry to delete.
Matrix(rw)->clear snmp targetaddr tr