Logging And Network Management Command Set
Configuring RMON
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-89
11.2.4.30 show rmon filter
Use this command to display one or more RMON filter entries.
show rmon filter [index index | channel channel]
Syntax Description
Command Defaults
If no options are specified, information for all filter entries will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display all RMON filter entries and channel information:
index index |
channel channel
(Optional) Displays information about a specific filter
entry, or about all filters which belong to a specific channel.
Matrix(rw)->show rmon filter
Index= 55508 Channel Index= 628 EntryStatus= valid
----------------------------------------------------------
Data Offset 0 PktStatus 0
PktStatusMask 0 PktStatusNotMask 0
Owner ETS,NAC-D
-----------------------------
Data
ff ff ff ff ff ff
-----------------------------
DataMask
ff ff ff ff ff ff
-----------------------------
DataNotMask
00 00 00 00 00 00
To Next Page
Loading...
