Enterasys Matrix 2G4072-52 - Set Spantree Adminedge

Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
6-112 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.2.20 set spantree adminedge
Use this command to set the edge port administrative status on a Spanning Tree port.
set spantree adminedge port-string {true | false}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set fe.1.11 as an edge port:
port-string Specifies the edge port. For a detailed description of
possible port-string values, refer to Section 4.1.1.
true | false Enables (true) or disables (false) the specified port as a
Spanning Tree edge port.
Matrix(rw)->set spantree adminedge fe.1.11 true