Matrix DFE-Platinum and Diamond Series Configuration Guide 2-1
2
Startup and General Configuration
This chapter describes factory default settings and the Startup and General Configuration set of
commands.
2.1 STARTUP AND GENERAL CONFIGURATION SUMMARY
At startup, the Matrix Series device is configured with many defaults and standard features. The
following sections provide information on how to review and change factory defaults, how to
customize basic system settings to adapt to your work environment, and how to prepare to run the
device in router mode.
2.1.1 Factory Default Settings
The following tables list factory default device settings available on the Matrix Series device.
Table 2-1 lists default settings for Matrix Series switch operation. Table 2-2 lists default settings for
router mode operation.
Table 2-1 Default Device Settings for Basic Switch Operation
Device Feature Default Setting
CDP discovery
protocol
Auto enabled on all ports.
CDP authentication
code
Set to 00-00-00-00-00-00-00-00
CDP hold time Set to 180 seconds.
CDP interval Transmit frequency of CDP messages set to 60 seconds.
Cisco Discovery
Protocol
Globally auto-enabled, enabled on ports.
To Next Page
Loading...
Need help?
General