Enterasys Matrix 2G4072-52 - Clear Netflow Export-Destination

Logging And Network Management Command Set
Configuring NetFlow
11-160 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.8.5 clear netflow export-destination
Use this command to clear the NetFlow collector IP address.
clear netflow export-destination [ip-address [udp-port]]
Syntax Description
Command Defaults
Since only one collector address per Matrix system is supported, entering the IP
address and UDP port information is not required. Executing this command
without any parameters will return the collector address to “Not Configured.”
Command Type
Switch command.
Command Mode
Read-Write
Example
This example shows how to clear the NetFlow collector address
:
ip-address (Optional) Specifies the IP address of the NetFlow collector
to clear.
udp-port (Optional) Specifies the UDP port number used by
NetFlow collector.
Matrix(rw)->clear netflow export-destination