SNMP Configuration Command Set
Configuring SNMP Users, Groups and Communities
Matrix DFE-Platinum and Diamond Series Configuration Guide 5-17
5.3.2.3 clear snmp user
Use this command to remove a user from the SNMPv3 security-model list.
clear snmp user user [remote remote]
Syntax Description
Command Defaults
If remote is not specified, the user will be removed from the local SNMP engine.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to remove the SNMP user named “bill”:
user Specifies an SNMPv3 user to remove.
remote remote (Optional) Removes the user from a specific remote
SNMP engine.
Matrix(rw)->clear snmp user bill
To Next Page
Loading...
