Port Configuration Command Set
Enabling / Disabling Jumbo Frame Support
4-50 Matrix DFE-Platinum and Diamond Series Configuration Guide
4.3.5.3 clear port jumbo
Use this command to reset jumbo frame support status to enabled on one or more ports.
clear port jumbo [port-string]
Syntax Description
Command Defaults
If port-string is not specified, jumbo frame support status will be reset on all ports.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset jumbo frame support status for 1-Gigabit Ethernet port 14 in
module 3:
port-string (Optional) Specifies the port(s) on which to reset jumbo
frame support status to enabled. For a detailed
description of possible port-string values, refer to
Section 4.1.1.
Matrix(rw)->clear port jumbo ge.3.14
To Next Page
Loading...
