General Configuration Command Set
Activating Licensed Features
2-92 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.4.1 set license
When an advanced license is available, use this command to activate licensed features. If this is
available on your Matrix Series device, a unique license key will display in the show license
command output.
set license {advanced | user-capacity | port-capacity} license-key [slot slot]
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
If not specified, the license will be bound to all modules.
Example
This example shows how to use license key abcdefg123456789 to activate advanced routing
features:
advanced Activates advanced routing features.
user-capacity Activates increased system user capacity to 2048 users per
system.
port-capacity Activates increased port user capacity to 256 users per port,
up to a maximum of 1024 users per module.
license-key Specifies your unique 16-digit hexadecimal advanced
licensing key.
NOTE: When available, the licensing key will
display at the top of the show running-config
command output.To see an example of this
output, refer to Section 12.2.2.1.
slot slot (Optional) Specifies a module to which the license will be
bound.
Matrix(rw)->set license advanced abcdefg123456789
To Next Page
Loading...
Need help?
General