VLAN Configuration Command Set
Configuring the VLAN Egress List
7-30 Matrix DFE-Platinum and Diamond Series Configuration Guide
7.3.4.1 show port egress
Use this command to display the VLAN membership for one or more ports.
show port egress [port-string]
Syntax Description
Command Defaults
If port-string is not specified, VLAN membership will be displayed for all ports.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows you how to show VLAN egress information for Fast Ethernet ports 1 through
3 in module 1. In this case, all three ports are allowed to transmit VLAN 1 frames as tagged and
VLAN 10 frames as untagged. Both are static VLANs:
port-string (Optional) Displays VLAN membership for specific
port(s). For a detailed description of possible port-string
values, refer to Section 4.1.1.
Matrix(rw)->show port egress fe.1.1-3
Port Vlan Egress Registration
Number Id Status Status
-------------------------------------------------------
fe.1.1 1 tagged static
fe.1.1 10 untagged static
fe.1.2 1 tagged static
fe.1.2 10 untagged static
fe.1.3 1 tagged static
fe.1.3 10 untagged static
To Next Page
Loading...
