IGMP Configuration Command Set
Configuring IGMP
Matrix DFE-Platinum and Diamond Series Configuration Guide 10-19
10.4.2.10 show igmp static
Use this command to display static IGMP ports for one or more VLANs or IGMP groups.
show igmp static vlan-list [group group]
Syntax Description
Command Defaults
If not specified, static IGMP information will be displayed for all groups.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display static IGMP information for VLAN 105. The display is similar
to the show igmp groups display:
vlan-list Specifies the VLAN(s) for which to display static IGMP
information.
group group (Optional) Displays information for a specific IGMP group
(IP address).
Matrix(rw)->show igmp static 105
-----------------------------------------------------------
Vlan Id = 105 Multicast Group Address = 224.0.0.2 Type = IGMP
IGMP Port List = fe.2.2 ge.3.14
To Next Page
Loading...
