Process Overview: SNMP Configuration
Reviewing SNMP Statistics
Matrix DFE-Platinum and Diamond Series Configuration Guide 5-5
5.2 PROCESS OVERVIEW: SNMP CONFIGURATION
Use the following steps as a guide to configuring SNMP on the device:
1. Reviewing SNMP statistics (Section 5.3.1)
2. Configuring SNMP users, groups and communities (Section 5.3.2)
3. Configuring SNMP access rights (Section 5.3.3)
4. Configuring SNMP MIB views (Section 5.3.4)
5. Configuring SNMP target parameters (Section 5.3.5)
6. Configuring SNMP target addresses (Section 5.3.6)
7. Configuring SNMP notification parameters (Section 5.3.7)
8. Creating a basic SNMP trap notification (Section 5.3.8)
5.3 SNMP CONFIGURATION COMMAND SET
5.3.1 Reviewing SNMP Statistics
Purpose
To review SNMP statistics.
Commands
The commands used to review SNMP statistics are listed below and described in the associated
section as shown.
• show snmp engineid (Section 5.3.1.1)
• show snmp counters (Section 5.3.1.2)
NOTE: Commands for configuring SNMP on the Matrix Series device are independent
during the SNMP setup process. For instance, target parameters can be specified when
setting up optional notification filters — even though these parameters have not yet
been created with the set snmp targetparams command. The following steps are a
guideline to configuring SNMP and do not necessarily need to be executed in this order.
To Next Page
Loading...
