Enterasys Matrix 2G4072-52 - Clear Inlinepower Threshold

General Configuration Command Set
Configuring Power over Ethernet (PoE)
2-108 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.5.11 clear inlinepower threshold
Use this command to reset the PoE usage threshold on a specified module to the default value of 75
percent.
clear inlinepower threshold module-number
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the PoE threshold to 75 on module 1:
module-number Specifies the module on which to reset the PoE threshold.
Matrix(rw)->clear inlinepower threshold 1