Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
3-30 Matrix DFE-Platinum and Diamond Series Configuration Guide
3.2.4.3 show lldp port trap
Use this command to display the ports that are enabled to send an LLDP notification when a remote
system change has been detected or an LLDP-MED notification when a change in the topology has
been sensed. Ports are enabled to send LLDP notifications with the set lldp port trap command and
to send LLDP-MED notifications with the set lldp port med-trap command.
show lldp port trap [port-string]
Syntax Description
Command Defaults
If port-string is not specified, LLDP port trap information will be displayed for all
ports.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display LLDP port trap information for all ports.
port-string (Optional) Displays the port or range of ports that have
been enabled to send LLDP and/or LLDP-MED
notifications.
Matrix(ro)->show lldp port trap
Trap-Enabled Ports :
MED Trap-Enabled Ports:
To Next Page
Loading...
