Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
Matrix DFE-Platinum and Diamond Series Configuration Guide 3-31
3.2.4.4 show lldp port tx-tlv
Use this command to display information about which optional TLVs have been configured to be
transmitted on ports. Ports are configured to send optional TLVs with the set lldp port tx-tlv
command.
show lldp port tx-tlv [port-string]
Syntax Description
Command Defaults
If port-string is not specified, TLV configuration information will be displayed for
all ports.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display transmit TLV information for three ports.
port-string (Optional) Displays information about TLV configuration
for one or a range of ports.
Matrix(ro)->show lldp port tx-tlv ge.1.1-3
* Means TLV is supported and enabled on this port
o Means TLV is supported on this port
Means TLV is not supported on this port
Column Pro Id uses letter notation for enable: s-stp, l-lacp, g-gvrp
Ports Port Sys Sys Sys Mgmt Vlan Pro MAC PoE Link Max MED MED MED MED
Desc Name Desc Cap Addr Id Id PHY Aggr Frame Cap Pol Loc PoE
------- ---- ---- ---- --- ---- ---- ---- --- --- ---- ---- --- --- --- ---
ge.1.1 * * * * * * slg * * * * * *
ge.1.2 * * * * * * slg * * * * * *
ge.1.3 * * * * * * slg * * * * * *
To Next Page
Loading...
Need help?
General