Port Configuration Command Set
Configuring Broadcast Suppression
4-86 Matrix DFE-Platinum and Diamond Series Configuration Guide
4.3.9.2 set port broadcast
Use this command to set the broadcast suppression limit, in packets per second, on one or more
ports. This sets a threshold on the broadcast traffic that is received and switched out to other ports.
set port broadcast port-string threshold-val
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set broadcast suppression to 800 packets per second on Fast Ethernet
ports 1 through 5 in module 1:
port-string Specifies the port(s) for which to set broadcast
suppression. For a detailed description of possible
port-string values, refer to Section 4.1.1.
threshold-val Sets the packets per second threshold on broadcast traffic.
Maximum value is 1488100 for Gigabit and 148810 for
Fast Ethernet. If set to the maximum value, thresholding
will be disabled.
Matrix(rw)->set port broadcast fe.1.1-5 800
To Next Page
Loading...
Need help?
General