IP Configuration Command Set
Configuring Dynamic Host Configuration Protocol (DHCP)
Matrix DFE-Platinum and Diamond Series Configuration Guide 12-137
12.2.9.21 show ip dhcp binding
Use this command to display information about one or all DHCP address bindings.
show ip dhcp binding [ip-address]
Syntax Description
Command Type
Router command.
Command Mode
Any DHCP configuration mode.
Command Defaults
If ip-address is not specified, information about all address bindings will be shown.
Example
This example shows how to display the DHCP binding address parameters, including an associated
Ethernet MAC addresses, lease expiration dates, type of address assignments, and whether the lease
is active:
ip-address (Optional) Displays bindings for a specific client IP address.
Matrix>(config-dhcp-pool)#show ip dhcp binding
IP address Hardware address Lease expiration Type Act.
172.28.1.249 00a0.c976.6d38 APR 09 2004 03:33PM Automatic Y
172.28.1.254 00a0.ccd1.12f8 Infinite Manual Y
To Next Page
Loading...
Need help?
General