Discovery Protocols Command Set
Displaying Neighbors
3-2 Matrix DFE-Platinum and Diamond Series Configuration Guide
3.2.1.1 show neighbors
Use this command to display Network Neighbor Discovery information from all supported
discovery protcols.
show neighbors [port-string]
Syntax Description
Command Defaults
If port-string is not specified, all Network Neighbor Discovery information will be
displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display Network Neighbor Discovery information:
port-string (Optional) Displays Network Neighbor Discovery
information for a specific port. For a detailed description of
possible port-string values, refer to Section 4.1.1.
To Next Page
Loading...
