VLAN Configuration Command Set
Configuring the VLAN Egress List
Matrix DFE-Platinum and Diamond Series Configuration Guide 7-35
7.3.4.5 set vlan dynamicegress
Use this command to set the administrative status of one or more VLANs’ dynamic egress
capability. If VLAN dynamic egress is enabled, the device will add the port receiving a tagged
frame to the VLAN egress list of the port according to the frame VLAN ID.
set vlan dynamicegress vlan-list {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable the dynamic egress function on VLAN 7:
vlan-list Specifies the number of the VLAN(s) where dynamic
egress will be enabled or disabled.
enable | disable Enables or disables dynamic egress.
Matrix(rw)->set vlan dynamicegress 7 enable
To Next Page
Loading...
