Enterasys Matrix 2G4072-52 - Set Spantree Portadmin

Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-97
6.2.2.5 set spantree portadmin
Use this command to disable or enable the Spanning Tree algorithm on one or more ports.
set spantree portadmin port-string {disable | enable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable Spanning Tree on fe.1.5:
port-string Specifies the port(s) for which to enable or disable
Spanning Tree. For a detailed description of possible
port-string values, refer to Section 4.1.1.
disable | enable Disables or enables Spanning Tree.
Matrix(rw)->set spantree portadmin fe.1.5 disable