Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
6-104 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.2.12 clear spantree portpri
Use this command to reset the bridge priority of a Spanning Tree port to a default value of 128.
clear spantree portpri port-string [sid sid]
Syntax Description
Command Defaults
If sid is not specified, port priority will be set for Spanning Tree 0.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the priority of fe.1.3 to 128 on SID 1:
port-string Specifies the port(s) for which to set Spanning Tree port
priority. For a detailed description of possible port-string
values, refer to Section 4.1.1.
sid sid (Optional) Resets the port priority for a specific Spanning
Tree identifier. Valid values are 0 - 4094. If not specified,
SID 0 will be assumed.
Matrix(rw)->clear spantree portpri fe.1.3 sid 1
To Next Page
Loading...
