Logging And Network Management Command Set
Configuring Simple Network Time Protocol (SNTP)
11-122 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.6.1 show sntp
Use this command to display SNTP client settings.
show sntp
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display SNTP client settings:
Table 11-14 provides an explanation of the command output.
Matrix(rw)->show sntp
SNTP Version: 3
Current Time: TUE SEP 09 16:13:33 2003
Timezone: 'EST', offset from UTC is -4 hours and 0 minutes
Client Mode: unicast
Broadcast Delay: 3000 microseconds
Broadcast Count: 0
Poll Interval: 512 seconds
Poll Retry: 1
Poll Timeout: 5 seconds
SNTP Poll Requests: 1175
Last SNTP Update: TUE SEP 09 16:05:24 2003
Last SNTP Request: TUE SEP 09 16:05:24 2003
Last SNTP Status: Success
SNTP-Server Precedence Status
-------------------------------------------
10.2.8.6 2 Active
144.111.29.19 1 Active
To Next Page
Loading...
Need help?
General