Security Configuration Command Set
Configuring Policy-Based Routing
14-176 Matrix DFE-Platinum and Diamond Series Configuration Guide
14.3.13.4 set next hop
Use this command to set one or more next hop IP address for packets matching an extended access
list in a configured route map. Up to five next hops can be specified.
set next hop {next-hop1}[next-hop2....next-hop5]
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command deletes next hop IP address(es):
no set next hop {next-hop1}[next-hop2....next-hop5]
Command Type
Router command.
Command Mode
Policy-based routing configuration: Matrix>Router1(config-route-map-pbr)#
Command Defaults
None.
Example
This example shows how to set IP address 10.2.3.4 as the next hop for packets matching ACL 1:
next-hop Specifies a next hop IP address(es). Up to five can be
configured.
Matrix>Router1(config)#route-map 101 permit 20
Matrix>Router1(config-route-map-pbr)#match ip address 1
Matrix>Router1(config-route-map-pbr)#set next-hop 10.2.3.4
To Next Page
Loading...
