Security Configuration Command Set
Configuring Flow Setup Throttling (FST)
14-192 Matrix DFE-Platinum and Diamond Series Configuration Guide
14.3.15.3 set flowlimit limit
Use this command to set a flow limit that will trigger an action for a port user classification. Once
configured, this limit can be:
• associated with an action using the set flowlimit action command as described in
Section 14.3.15.5.
• assigned to one or more ports using the set flowlimit class command as described in
Section 14.3.15.8.
set flowlimit {limit1 | limit2 limit} [userport | serverport | aggregateduser |
interswitchlink | unspecified]
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
If classification port type is not specified, none will be applied.
limit1 | limit2 Specifies this configuration as limit 1 or 2. Two limits
assigned to two actions (describing what will occur when a
certain flow limit is reached) can be defined per user
classification.
limit Specifies the number of flows that will trigger the
associated action configuration. Valid values are 0 -
4294967295.
userport |
serverport |
aggregateduser |
interswitchlink |
unspecified
(Optional) Assigns this limit configuration to the user
classification port type:
• user port
• server port
• aggregation port
• inter-switch link
• unspecified port
To Next Page
Loading...
Need help?
General