Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6-56 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.1.43 set spantree legacypathcost
Use this command to enable or disable legacy (802.1D) path cost values.
set spantree legacypathcost {disable | enable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the default path cost values to 802.1D:
NOTE: By default, legacy path cost is disabled. Enabling the device to calculate legacy
path costs affects the range of valid values that can be entered in the
set spantree
adminpathcost
command (Section 6.2.2.17).
disable | enable Enables or disables legacy (802.1D) path cost values.
Matrix(rw)->set spantree legacypathcost enable
To Next Page
Loading...
Need help?
General