IP Configuration Command Set
Configuring Routing Interface Settings
12-4 Matrix DFE-Platinum and Diamond Series Configuration Guide
12.2.1.1 show interface
Use this command to display information about one or more interfaces (VLANs or loopbacks)
configured on the router.
show interface [vlan vlan-id | loopback loopback-id | lo local-id]
Syntax Description
Command Type
Router command.
Command Mode
Any router mode.
Command Defaults
If interface type is not specified, information for all routing interfaces will be
displayed.
vlan vlan-id |
loopback
loopback-id | lo
local-id
(Optional) Displays interface information for a specific
VLAN, loopback, or local interface. This interface must be
configured for IP routing as described in Section 2.3.1.
To Next Page
Loading...
