Security Configuration Command Set
Configuring Port Web Authentication (PWA)
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-73
14.3.6.18 set pwa quietperiod
Use this command to set the amount of time a port will remain in the held state after a user
unsuccessfully attempts to log on to the network.
set pwa quietperiod time [port-string]
Syntax Description
Command Type
Switch command.
Command Defaults
If port-string is not specified, quiet period will be set for all ports.
Command Mode
Read-Write.
Example
This example shows how to set the PWA quiet period to 30 seconds for ports fe.1.5-7:
time Specifies quiet time in seconds.
port-string (Optional) Sets the quiet period for specific port(s). For a
detailed description of possible port-string values, refer
to Section 4.1.1.
Matrix(rw)->set pwa quietperiod 30 fe.1.5-7
To Next Page
Loading...
