IGMP Configuration Command Set
Configuring IGMP
10-20 Matrix DFE-Platinum and Diamond Series Configuration Guide
10.4.2.11 set igmp add-static
Use this command to create a new static IGMP entry, or to add one or more new ports to an existing
entry.
set igmp add-static group vlan-list [modify] [include-ports] [exclude-ports]
Syntax Description
Command Defaults
If not specified, the static entry will be created and not modified.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to add port fe.1.3 to the IGMP group at 224.0.2 (VLAN 105):
group Specifies a group IP address for the entry.
vlan-list Specifies the VLAN(s) on which to configure the entry.
modify Adds new ports to an existing entry.
include-ports Port or range of ports
exclude-ports Port or range of ports
Matrix(rw)->set igmp add-static 224.0.0.2 105 modify
include-ports fe.1.3
To Next Page
Loading...
