Enterasys Matrix 2G4072-52 - Show Port Speed

Port Configuration Command Set
Setting Speed and Duplex Mode
Matrix DFE-Platinum and Diamond Series Configuration Guide 4-43
4.3.4.1 show port speed
Use this command to display the default speed setting on one or more ports.
show port speed [port-string]
Syntax Description
Command Defaults
If port-string is not specified, default speed settings for all ports will display.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the default speed setting for 1-Gigabit Ethernet port 14 in
module 3:
port-string (Optional) Displays default speed setting(s) for specific
port(s). For a detailed description of possible
port-string values, refer to Section 4.1.1.
Matrix(rw)->show port speed ge.3.14
default speed is 1000 on port ge.3.14.