Discovery Protocols Command Set
Cisco Discovery Protocol
Matrix DFE-Platinum and Diamond Series Configuration Guide 3-17
3.2.3.3 set ciscodp status
Use this command to enable or disable Cisco Discovery Protocol globally on the device.
set ciscodp status {auto | enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable Cisco Discovery Protocol on the device:
auto Globally enable only if CiscoDP PDUs are received
enable Globally enables Cisco Discovery Protocol
disable Globally disables Cisco Discovery Protocol
Matrix>set ciscodp status enable
To Next Page
Loading...
