Configuring Port Mirroring
Setting Port Mirroring
4-94 Matrix DFE-Platinum and Diamond Series Configuration Guide
4.4.4.3 clear port mirroring
Use this command to clear a port mirroring relationship.
clear port mirroring {igmp-mcast | source destination}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to clear port mirroring between source port fe.1.4 and target port fe.1.11:
igmp-mcast Clears IGMP multicast mirroring.
source Specifies the source port of the mirroring configuration to
be cleared. For a detailed description of possible
port-string values, refer to Section 4.1.1.
destination Specifies the target port of the mirroring configuration to
be cleared.
Matrix(rw)->clear port mirroring fe.1.4 fe.1.11
To Next Page
Loading...
