Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-19
6.2.1.7 clear spantree stpmode
Use this command to reset the Spanning Tree protocol mode to the default setting of IEEE802.1.
This re-enables Spanning Tree.
clear spantree stpmode
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the STP mode to IEEE 802.1:
Matrix(rw)->clear spantree stpmode
To Next Page
Loading...
