Enterasys Matrix 2G4072-52 - Set Pwa

Security Configuration Command Set
Configuring Port Web Authentication (PWA)
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-57
14.3.6.2 set pwa
Use this command to enable or disable port web authentication.
set pwa {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable port web authentication:
NOTE: Port Web Authentication cannot be enabled if either MAC authentication or
EAPOL (802.1X) is enabled. For information on disabling 802.1X, refer to
Section 14.3.5.3. For information on disabling MAC authentication, refer to
Section 14.3.7.3.
enable | disable Enables or disables port web authentication.
Matrix(rw)->set pwa enable