Routing Protocol Configuration Command Set
Configuring OSPF
13-34 Matrix DFE-Platinum and Diamond Series Configuration Guide
13.2.3.1 router ospf
Use this command to enable or disable Open Shortest Path First (OSPF) configuration mode.
router ospf process-id
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command disables OSPF configuration mode:
no router ospf process-id
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router1(config)#
Command Defaults
None.
Example
This example shows how to enable routing for OSPF process 1:
NOTES: You must execute the router ospf command to enable the protocol before
completing many OSPF-specific configuration tasks. For details on enabling
configuration modes, refer to Table 2-9 in Section 2.3.3.
Only one OSPF process (process-id) is allowed per Matrix Series routing module or
standalone device.
process-id Specifies the process ID, an internally used identification
number for an OSPF routing process run on a router. Only
one OSPF process is allowed per device. Valid values are 1
to 65535.
Matrix>Router1#conf terminal
Matrix>Router1(config)#router ospf 1
Matrix>Router1(config-router)#
To Next Page
Loading...
