VLAN Configuration Command Set
Assigning Port VLAN IDs (PVIDs) and Ingress Filtering
Matrix DFE-Platinum and Diamond Series Configuration Guide 7-13
7.3.3.1 show port vlan
Use this command to display port VLAN identifier (PVID) information. PVID determines the
VLAN to which all untagged frames received on one or more ports will be classified.
show port vlan [port-string]
Syntax Description
Command Defaults
If port -string is not specified, port VLAN information for all ports will be
displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display PVIDs assigned to Fast Ethernet ports 1 through 6 in module
2. In this case, untagged frames received on these ports will be classified to VLAN 1:
port-string (Optional) Displays PVID information for specific
port(s). For a detailed description of possible port-string
values, refer to Section 4.1.1.
Matrix(rw)->show port vlan fe.2.1-6
fe.2.1 is set to 1
fe.2.2 is set to 1
fe.2.3 is set to 1
fe.2.4 is set to 1
fe.2.5 is set to 1
fe.2.6 is set to 1
To Next Page
Loading...
